Workflows
A whole job on one page. Enter what the job needs, and every step is worked out from your values.
Pilots
- VFR preflight
Check the weather, the altitude your airplane will perform at, and the wind on your runway before you go.
4 steps - VFR cross-country
Plan a cross-country: heading, groundspeed, time, and fuel for every leg, the climb, the reserve, and whether you land before dark.
4 steps - Preflight performance check
Find how much runway the airplane needs today, from the weather and the takeoff table in your POH, before you commit to the departure.
5 steps
Everyone
- Convert a coordinate
Paste a coordinate in any form and get it in every other form, each ready to copy.
8 steps
Instrument pilots
- IFR approach brief
Brief the hold and the approach: entry, speed limit, wind-corrected headings and timing, and where to start down.
6 steps
Drone operators
- Drone mapping day
Plan a mapping flight from the resolution you need: height, photos, batteries and swap points, line of sight from where you stand, and the light.
10 steps - Can I fly now?
Check the wind at your flying height against your drone, the light, and how high you may go, before you launch.
4 steps - Plan an inspection
Plan an orbit around a tower or building: the path, the gimbal angle, the detail you will capture, and whether you can see it all.
3 steps
Surveyors
- GNSS control to OPUS to state plane
Turn a GNSS position into NAD83(2011) state plane coordinates, an orthometric height, and a ground distance.
5 steps - Boundary retracement from a deed
Plot a deed, check that it closes, and rotate its bearings to your basis.
3 steps - Lay out a road curve
Work out the circular curve and the vertical curve of a road together, and see where each begins and ends against the other.
2 steps
Drone operators and surveyors
- Lidar bid
Size a lidar job for a bid: the flight lines, the batteries, and the checkpoints the accuracy class needs.
5 steps
Developers
- Developer: index to area
Pick an H3 resolution for the area you care about, then index a point and fill a polygon.
5 steps